Cal Amp VIPER SC+ 100 series User Manual - page 48
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 38
LAN MAC Address
The MAC Address on the Ethernet port of the Viper.
Uptime
The duration in days, hours, minutes, and seconds (DD:HH:MM:SS) that the unit has been powered up and
operational since the last reset.
Modem Firmware Version
The version of the firmware currently running on the Viper.
Unit Status
Displays the status of the Viper and reports any errors. Have the content of the displayed Unit Status message
available when contacting CalAmp Technical Support. This information is also required if returning a unit for
service under an RMA.
IP Forwarding Mode
Displays the IP Forwarding Mode, whether the Viper is operating as a bridge or router. The IP Forwarding Mode is
configured in RF Network Settings » RF Network.
Station Mode
Displays whether the unit is configured to operate as a Relay Point, Access Point, or Remote. The Station Mode is
also configured in RF Network Settings » RF Network.
DC Input Voltage
Displays the system input voltage currently seen by the unit.
Transceiver Temperature
Displays the transceiver input temperature. The Viper can be configured to display temperature in Celsius or
Fahrenheit in the Basic Settings tab.
VPN Status
Displays the status of the VPN (Virtual Private Network). When operational will display OK/Ready. If the VPN is not
operational, Not Ready and the reason it is not operational will display.
Refresh — Click Refresh to update the information displayed in the current tab.
Acknowledge Unit Status — This button allows you to acknowledge and clear errors. Errors remain stored, even after
cycling power, to aid in troubleshooting intermittent faults. Click the Acknowledge Unit Status button to return web
page displays and unit Status LED function to normal operation.