Cal Amp VIPER SC+ 100 series User Manual - page 41
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 31
3.7. INITIAL CONFIGURATIO N USING THE SETUP WIZARD
The first page of the Setup Wizard displays navigation information for the wizard
Figure 19 – Setup Wizard Welcome and Instructions
The Setup Wizard consists of five (5) steps. Each step is presented as a single page with a few simple options to fill in or
select. Each of the five pages for each step of the Setup Wizard that follow contain the basic configuration settings that
are most commonly required to select or change to set up the Viper SC+ IP router for specific functionality.
The steps are as follows.
Step 1: Station Name and Mode settings: Station Name, IP Forwarding Mode, Relay Point, Access Point, and Multi-
Speed Mode.
Step 2: Network IP settings: IP Address, Network Mask, and Default Gateway.
Step 3: Radio Setup: Bandwidth, Data and Control Packet Bit Rate, Rx and Tx Frequency ranges, and Tx Power.
Step 4: Encryption: Enable or Disable, and Encryption Pass Phrase.
Step 5: Setup completion and Viper reset.
Instructions for each of these steps are provided on the following pages.
Note: some settings (indicated by a yellow alert symbol
) in the Viper Setup Wizard, require a reset of the Viper
before they will take effect. When you have finished with the Viper Setup Wizard, it will be necessary to reset the Viper
to restart with the new configuration settings made in the Setup Wizard.
When you have read the information provided on the Welcome page carefully, click Quit to exit or click Next to
proceed to Step 1 on the following page.