Cal Amp VIPER SC+ 100 series User Manual - page 105
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 95
Table 15 TCP/UDP Parameter Usage
UDP Mode
TCP Client Mode
TCP Server Mode
TCP Client/Server Mode
Local IP
Address
REQUIRED
Value
Automatic = Let the
IP stack decide.
Ethernet = IP address
of the Ethernet
interface.
RF = IP address of the
RF interface.
Virtual 1…5 = IP
address of the
specified virtual
interface.
REQUIRED
Value
Automatic = Let the
IP stack decide.
Ethernet = IP address
of the Ethernet
interface.
RF = IP address of the
RF interface.
Virtual 1…5 = IP
address of the
specified virtual
interface.
REQUIRED
Value
Automatic = Let the
IP stack decide.
Ethernet = IP address
of the Ethernet
interface.
RF = IP address of the
RF interface.
Virtual 1…5 = IP
address of the
specified virtual
interface.
REQUIRED
Value
Automatic = Let the
IP stack decide.
Ethernet = IP address
of the Ethernet
interface.
RF = IP address of the
RF interface.
Virtual 1…5 = IP
address of the
specified virtual
interface.
Local Port
Number
REQUIRED
Value
* 1 - 65535
Do not use:
20, 21, 23, 123,
520, or 5002
UNUSED
Value
* IP stack decides the
value.
REQUIRED
Value
* 1 - 65535
Do not use:
20, 21, 23, 123,
520, or 5002
REQUIRED
Value
* 1 - 65535
Do not use:
20, 21, 23, 123,
520, or 5002
Remote IP
Address
REQUIRED
Value
* Unicast IP address
OR
* Broadcast IP address
OR
* Multicast IP address
REQUIRED
Value
* Unicast IP address
based on Local IP
selection for TCP reply
message
REQUIRED
Value
N/A
REQUIRED
Value
* Unicast IP address
based on Local IP
selection for TCP reply
message
Remote
Port
Number
REQUIRED
Value
* 1 - 65535
REQUIRED
Value
* 1 - 65535
REQUIRED
Value
* 1 - 65535
REQUIRED
Value
* 1 - 65535
TCP
Keepalive
UNUSED
OPTIONAL
Value
** 0 – 1440 (minutes)
(0 = TCP Keepalive is
disabled)
OPTIONAL
Value
** 0 – 1440 (minutes)
(0 = TCP Keepalive is
disabled)
OPTIONAL
Value
** 0 – 1440 (minutes)
(0 = TCP Keepalive is
disabled)
* Avoid use of reserved port number values. (For example 20, 21, 23, 123, 520, 5002.)
** Setting the value of TCP Keepalive to zero (0) disables the sending of keepalive packets.
Local IP Address
The local IP address for IP Services. The default setting is Automatic.
Automatic – The Viper will respond any of the IPs assigned-Ethernet, RF, or virtual.
Ethernet – The Viper will respond only to the Ethernet IP address.
RF – The Viper will respond only to the RF IP address
Virtual 1…5 The Viper will respond only to the specified virtual interface.
Limit to Interface
Limit the access to the serial port to only a special class of packets. When this option is selected AND a specific
"Local IP Address" is selected, enforce the following rules: