Cal Amp VIPER SC+ 100 series User Manual - page 109
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 99
VID=0
If incoming packets have a VLAN ID set to zero (0), you can choose to silently drop these packets, keep them
unchanged, re-tag the packets with the PVID, or delete their tag. The default setting is to silently drop the packet.
VID=PVID (The packet has a VLAN ID that is the same as the PVID)
If incoming packets have a VLAN ID that is the same as the PVID, you can choose to silently drop these packets,
keep them unchanged, or delete their tag. The default setting is to keep the packet unchanged.
VID!=PVID (VID is not equal to PVID)
If incoming packets have a VLAN ID that is not the same as the PVID, you can choose to silently drop these packets,
keep them unchanged, re-tag the packets with PVID, or delete their tag. The default setting is to silently drop the
packet.
Egress Packet
Untagged (The packet has no VLAN ID tag)
If exiting packets are untagged, you can choose to silently drop these packets, keep them unchanged, or tag them
with PVID. The default setting is to keep the packet unchanged.
VID=0
If exiting packets have a VLAN ID set to zero (0), you can choose to silently drop these packets, keep them
unchanged, re-tag them with PVID, or delete their tag. The default setting is to silently drop the packet.
VID=PVID (The packet has a VLAN ID that is the same as the PVID)
If exiting packets have a VLAN ID that is the same as the PVID, you can choose to silently drop these packets, keep
them unchanged, or delete their tag. The default setting is to delete the tag.
VID!=PVID (VID is not equal to PVID)
If exiting packets have a VLAN ID that is not the same as the PVID, you can choose to silently drop these packets,
keep them unchanged, re-tag the packets with PVID, or delete their tag. The default setting is to silently drop the
packet.
Save — Click Save to save any changes you have made in this tab. See the Note that follows.
Cancel — Click Cancel to cancel any changes you may have made to any of the settings in this tab.
Note: If you change the Port VLAN ID (PVID) for either serial port, a reset of the Viper is required before the setting will
take effect, as indicated by the yellow alert symbol (
).