Cal Amp VIPER SC+ 100 series User Manual - page 98
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 88
Figure 52 – Router – VTS
Enable Virtual Terminal Server 1 through 5
Enable Virtual Server 1, Enable Virtual Server 2, Enable Virtual Server 3, … Enable Virtual Server 5
To enable an instance of the Virtual Terminal Server, click to place a check mark in the box.
Mode – There are three modes available.
TCP Server mode – Up to 128 TCP clients can connect to the TCP server.
TCP Client mode – The client will attempt connection to the TCP server identified by the remote address and
remote port number.
UDP – Receive UDP packets on the local port number and send UDP packets to the remote address and remote
port number.
Local IP Address
The source IP Address of outgoing packets is selected either automatically (by the IP stack) or it can be fixed to the
IP address associated with any of the interfaces.