Cal Amp VIPER SC+ 100 series User Manual - page 12
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 2
1.3. PHYSICAL DESCRIPTION
Viper consists of two logic PCBs, one that includes the modem circuitry and the other the radio module. Both are
installed in a cast aluminum case. The unit is not hermetically sealed and should be mounted in a suitable enclosure
when dust, moisture, and/or a corrosive atmosphere are anticipated.
1.3.1. CHASSIS DIMENSIONS
The following figure shows the dimensions of the Viper chassis and attached mounting plate.
Figure 1 – Viper SC+ Chassis and Mounting Plate Overall Dimensions and Mounting Hole Locations
The equipment is intended for installation only in a RESTRICTED ACCESS LOCATION per EN60950-1:2006.
1.3.2. LED PANEL
There are five (5) Tri-Color LEDs in the LED panel of the Viper as shown in the following figure. Their functionality is
described in the following table.
Figure 2 – Viper LED panel