Candy CFA 61 Instruction Manual - page 30
Under any circumstances, make sure the Induction hob is well ventilated and the
air inlet and outlet are not blocked. Ensure the Induction hob is in good work state.
As shown belo
Note: The safety distance between the hotplate and the cupboard above
the hotplate should be at least 760mm.
A(mm) B(mm)
C(mm)
D
E
760
50 mini 20 mini
Air intake Air exit 5mm
Before you install the hob, make sure that
• the work surface is square and level, and no structural members interfere with
space requirements.
• the work surface is made of a heat-resistant material.
• if the hob is installed above an oven, the oven has a built-in cooling fan.
• the installation will comply with all clearance requirements and applicable
standards and regulations.
• a suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements).
EN-29