D-Link DES-3526 - Switch - Stackable Manual - Layer 3 Ip Networking
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
116
Access
Toggle the Access field to either Permit or Deny to limit or grant access to a
specified range of Multicast addresses on a particular port or range of ports.
Click Apply to implement the new settings on the Switch.
Layer 3 IP Networking
Static ARP Table
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical
addresses. This table allows network managers to view, define, modify and delete ARP information
for specific devices.
Static entries can be defined in the ARP Table. When static entries are defined, a permanent entry is
entered and is used to translate IP address to MAC addresses.
To open the Static ARP Table open the Configuration folder, and then open the Layer 3 IP
Networking folder and click on the Static ARP Table link.
Figure 6- 84. Static ARP Settings window
To add a new entry, click the Add button, revealing the following window to configure:
Figure 6- 85. Static ARP Table – Add a New Entry window
The following fields can be set:
Parameter
Description
IP Address
The IP address of the ARP entry.
MAC Address
The MAC address of the ARP entry.
After entering the IP Address and MAC Address of the Static ARP entry, click Apply to implement
the new entry. To completely clear the Static ARP Settings, click the Clear All button.
NOTE: The Switch supports up to 255 static ARP entries.