D-Link DES-3526 - Switch - Stackable Manual - Authentication Server Hosts
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
127
NOTE: The three built in server groups can only have server
hosts running the same TACACS daemon.
TACACS/XTACACS/TACACS+
protocols are separate
entities and are not compatible with each other.
Authentication Server Hosts
This window will set user-defined Authentication Server Hosts for the
TACACS/XTACACS/TACACS+/RADIUS security protocols on the Switch. When a user attempts to
access the Switch with Authentication Policy enabled, the Switch will send authentication packets to a
remote TACACS/XTACACS/TACACS+/RADIUS server host on a remote host. The
TACACS/XTACACS/TACACS+/RADIUS server host will then verify or deny the request and return
the appropriate message to the Switch. More than one authentication protocol can be run on the same
physical server host but, remember that TACACS/XTACACS/TACACS+/RADIUS are separate
entities and are not compatible with each other. The maximum supported number of server hosts is 16.
To view the following window, click Security Management > Access Authentication Control >
Authentication Server Host:
Figure 7- 9. Authentication Server Host Settings window
To add an Authentication Server Host, click the Add button, revealing the following window:
Figure 7- 10. Authentication Server Host Settings – Add window
Configure the following parameters to add an Authentication Server Host:
Parameter Description