D-Link DES-3526 - Switch - Stackable Manual - page 23
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
10
Mounting the Switch in a Standard 19" Rack
CAUTION: Installing systems in a rack without the front and side stabilizers installed
could cause the rack to tip over, potentially resulting in bodily injury under certain
circumstances. Therefore, always install the stabilizers before installing components in
the rack. After installing components in a rack, do not pull more than one component
out of the rack on its slide assemblies at one time. The weight of more than one
extended component could cause the rack to tip over and may result in injury.
Figure 2- 3. Installing Switch in a rack
Power On AC Power
Plug one end of the AC power cord into the power connector of the Switch and the other end into the
local power source outlet.
After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED
indicators represents a reset of the system.
Power Failure
For AC power supply units, as a precaution, in the event of a power failure, unplug the Switch. When
power is resumed, plug the Switch back in.