D-Link DG-102S User Manual - Command Line Interface
DG-102S VoIP Station Gateway
46
7
Command Line Interface
The DG-102S VoIP gateway offers a line-at-a-time prompt and response scheme to execute various configuration
instructions. The interface displays a single prompt character ggdbg> when it is ready to accept a command (ex.
ggdbg>set or ggdbg>show).
Typing a question mark after the ggdbg> prompt will display a list of helpful user commands. Please note that
all characters must be entered in lower case. For the sake of explanation, all command line examples in this
chapter are in bold type.
See below for a list of some of the most commonly used commands, parameter(s), and examples of their usage.
General Setup Commands
nwdbg system reboot
Definition:
This command is used to restart the device.
Parameter(s):
None.
Example:
nwdbg system reboot
nwdbg save changes
Definition:
This command is used to save configuration changes into flash and then restart the device.
Parameter(s):
None.
Example:
nwdbg save changes
nwdbg factory reset
Definition:
This command is used to change all of the configuration data to the default values, save the
new configuration data into flash, and then restart the device.
Parameter(s):
None.
Example:
nwdbg factory reset
nwdbg un
Definition:
This command sets the username if there is a username string, or shows the
username/password if only nwdbg un is typed.
Parameter(s):
Example:
nwdbg un 123456789012
nwdbg pw
Definition:
This command sets the password if there is a password string, or shows the
username/password if only nwdbg pw is typed.
Parameter(s):
Example:
nwdbg pw
nwdbg slic <0|1>
Definition:
This command changes the Subscriber Line Interface Circuit (SLIC) state to standby or
active, or shows the SLIC state if only nwdbg slic is typed.
Parameter(s):
Example:
nwdbg slic 0