D-Link DG-102S User Manual - page 54
DG-102S VoIP Station Gateway
48
If only nwdbg ca is typed, this command shows the address.
Parameter(s):
[domainName|ip]:port or [domainName|ip]> Example: nwdbg ca 10.1.40.100:2427 nwdbg rgw Definition: This command sets the Residential Gateway Name. If only nwdbg rgw is typed, this command shows the RGW NAME. Parameter(s): Example: nwdbg rgw [RGW_1] nwdbg dns Definition: This command sets the Domain Name Server's IP address. If only nwdbg dns is typed, this command shows the DNS IP/STATE. Parameter(s): Example: nwdbg dns 10.1.1.5 nwdbg dns Definition: This command turns on/off the DNS function. If only nwdbg dns is typed, this command shows the DNS IP/STATE Parameter(s): [disable | enable] Example: nwdbg dns disable nwdbg country Definition: This command provides country code setting interface to config the tone frequency for different country. If only nwdbg country is typed, this command shows the COUNTRY CODE Parameter(s): <0:USA (Default), 1:Japan, 2:Hong Kong, 3:Sweden> Example: nwdbg country 1 nwdbg config Definition: This command shows all the configuration settings made by nwdbg commands. Parameter(s): None. Example: nwdbg config ping Definition: This command lets the user ping an IP address from the device. Parameter(s): -n count: Number of echo requests to send. -w timeout: Timeout in seconds to wait for each reply. -i interval: The interval in half-seconds between two echo requests.> Example: ping 10.1.1.6 -n 100 -w 2 -i 1 TFTP Client Setup Commands When the user enters tftp, the screen will show all commands about the TFTP client: ggdbg>tftp tftp srvip tftp get – get the remote image file