D-Link DG-102S User Manual - page 53
DG-102S VoIP Station Gateway
47
nwdbg dtmf_relay <0|1>
Definition:
This command turns the Dual Tone Multiple Frequency (DTMF) relay function on or off, or
shows the DTMF relay state if only nwdbg dtmf_relay is typed.
Parameter(s):
<0 : off, 1 : on>
Example:
nwdbg dtmf_relay 0
nwdbg mac
Definition:
This command sets the MAC address of the voice link, or shows the MAC address if only
nwdbg mac is typed.
Parameter(s):
Example:
nwdbg mac 00:50:ba:08:24:56
nwdbg ip
Definition:
This command sets the software boot mode to DHCP or BOOTP or Manual mode.
If only nwdbg ip is typed, this command shows the IP configuration.
DHCP: While the system is booting, the system acts as a DHCP client.
BOOTP: While the system is booting, the system acts as a BOOTP client. This mode is used
to set the device's IP address and upgrade the software.
Manual: While the system is booting, the system uses a fixed IP address. The fixed IP
address can be set by nwdbg ip
Parameter(s):
Example:
nwdbg ip dhcp
nwdbg ip
Definition:
This command sets the fixed IP address, which is used as the system's IP address if the
software boot mode is Manual mode.
If only nwdbg ip is typed, this command shows the IP configuration.
Parameter(s):
Example:
nwdbg ip 10.1.1.120
nwdbg mask
Definition:
This command sets the fixed subnet mask, which is used as the system's subnet mask if the
software boot mode is Manual mode.
If only nwdbg mask is typed, this command shows the IP configuration.
Parameter(s):
Example:
nwdbg mask 255.0.0.0
nwdbg gw
Definition:
This command sets the fixed GW address, which is used as the system's GW address if the
software boot mode is Manual mode.
If only nwdbg mask is typed, this command shows the IP configuration.
Parameter(s):
Example:
nwdbg gw 10.1.1.254
nwdbg tftp <0|1>
Definition:
This command sets the software download link to either a WAN link or a LAN link.
If only nwdbg tftp is typed, this command shows the download link.
Parameter(s):
<0:WAN link, 1:LAN link>
Example:
nwdbg tftp 0
nwdbg ca
Definition:
This command sets the address of notify entity.