D-Link DGS-3312SR Product Manual - L3 Global Advanced Settings
DGS-3312SR Gigabit Layer 3 Switch
L3 Global Advanced Settings
In order to use DVMRP, PIM-DM, RIP, or OSPF, the Switch must first be globally enabled. To enable or disable these
Layer 3 protocols as well as configure ARP Aging Time, access the L3 Global Advanced Settings window.
To enable DVMRP, PIM-DM, RIP or OSPF for the Switch, select Enabled for the global setting and click the Apply
button. You may later select Disabled for any of these to disable the protocol without changing any of the settings that may
have been configured for them.
Figure 5- 1. L3 Global Advanced Settings window
ARP aging timeout is the time in seconds that an entry is allowed to remain in the ARP dynamic entry table. To setup
permanent entries for ARP, use the Static ARP Settings window (described later in this chapter).
NOTE: PIM, RIP, OSPF, and DVMRP may also be globally enabled or
disabled using a separate global settings window for each protocol. The
links for the individual global settings windows are located in their
respective subfolders.
IP Interface Settings
Each VLAN must be configured prior to setting up the VLAN’s corresponding IP interface.
To set up IP interfaces, open the Layer 3 IP Networking sub-folder in the Configuration folder and then click IP
Interfaces Settings to open the following window:
Figure 5- 2. 1
st
IP Interface Settings window
Click the Add button to configure settings for a new IP interface. If you want to change an existing IP interface, click on
the hyperlinked Interface Name in the list.
92