D-Link DGS-3312SR Product Manual - Switch Information
DGS-3312SR Gigabit Layer 3 Switch
System Log Server
Port Security
SNTP Setting
Time Setting
Time Zone and DST
Access Profile Table
The DGS-3312SR’s Web interface is divided into six main folders: Configuration, Security, Management, Monitoring,
Maintenance, and Single IP Management. This chapter describes all of the Configuration sub-folders and windows
except those found in the Layer 3 IP Networking sub-folder, which are explained in the next chapter, “Advanced
Configuration.”
Switch Information
The first page displayed upon logging in is the System Information (Basic Settings) window. This window can be
accessed at any time by clicking the Switch Information button in the Configuration folder.
Figure 4- 1. Switch Information (Basic Settings) window
This window displays general information about the Switch including its MAC Address, Hardware Boot PROM and
Firmware versions, and installed module information.
IP Address
Switch IP settings may initially be set using the console interface prior to connecting to it through the Ethernet. If the
Switch IP address has not yet been changed, read the Introduction of the CLI Reference or skip ahead to the end of this
section for a quick description of how to use the console port and CLI IP settings commands to establish IP settings for the
Switch.
To change IP settings using the web manager you must access the Switch IP Settings window located in the
Configuration folder.
To configure the Switch’s IP address:
35