D-Link DI-304 User Manual - page 79

DI-304/DI-304M ISDN Remote Router 

♦ 

RX Pkts – 

Total number of received IP packets received during this 

connection session. 

♦ 

RX Rate – 

Reception rate for ingoing data. The unit is characters per 

second (cps). 

♦ 

Up Time – 

Connection time. The format is HH:MM:SS where HH means 

hours, MM means minutes, and SS means seconds. 

♦ 

AOC

– 

The Advice of Charge (AOC) service allows you to view 

information concerning charges for a call.  

♦ 

Drop B1 – 

Click to disconnect the B1 channel. 

♦ 

Drop B2 – 

Click to disconnect the B2 channel. 

LAN Status 

♦ 

IP Address – 

IP address of the LAN interface. 

♦ 

TX Packets – 

Total number of transmitted IP packets send since the 

router was powered on. 

♦ 

RX Packets – 

Total number of transmitted IP packets received since the 

router was powered on. 

WAN Status 

♦ 

Mode – 

Indicates which broadband access mode is active. Depending 

upon the broadband access mode, you may see Static IP, PPTP, or PPPoE. 

♦ 

GW IP Address – 

Indicates the gateway IP address. 

♦ 

IP Address – 

The 2nd IP Address of Ethernet or the IP address of WAN 

interface that is from PPTP/PPPoE connection. 

♦ 

TX Packets – 

Total number of transmitted IP packets sent during this 

connection session. 

♦ 

TX Rate – 

Transmission rate for outgoing data. The unit is characters per 

second (cps). 

♦ 

RX Packets – 

Total number of transmitted IP packets received during 

this connection session.

♦ 

RX Rate – 

Reception rate for ingoing data. The unit is characters per 

second (cps). 

♦ 

Up Time – 

Connection time. The format is HH:MM:SS where HH means 

hour, MM means minute, and SS means second. 

♦ 

Drop PPPoE or PPTP – 

Click to disconnect the PPPoE or PPTP 

connection. 

Time Setup 

Click 

Time Setup

 to open a page that allows you to make configuration changes to 

the time setup. 

71