D-Link xStack DGS-3426P User Manual - Ip-Mac Binding Table

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch 

IP-MAC Binding Table 

The window shown below can be used to create IP-MAC binding entries. Enter the IP and MAC addresses of the authorized users 

in the appropriate fields and click 

Add

. To modify either the IP address or the MAC address of the binding entry, make the 

desired changes in the appropriate field and Click 

Modify

. To find an IP-MAC binding entry, enter the IP and MAC addresses 

and click 

Find

. To delete an entry click 

Delete

. To clear all the entries from the table click 

Delete All

.  To view this table click, 

Administration > IP-MAC-Port Binding >

IP-MAC Binding Table

. 

Figure 6- 69. IP-MAC Binding Table window 

The following fields can be set or modified: 

Parameter                    Description 

Address Binding 

ACL Mode 

This field will enable and disable the ACL mode for IP-MAC binding on the Switch, without 

altering previously set configurations. When enabled, the Switch will automatically create two 

ACL packet content mask entries, which will aid the user in processing certain IP-MAC binding 

entries created. The ACL entries created when this command is enabled, can only be 

automatically installed if the Access Profile table has two entries available of the possible 255 

entries allowed. 

ACL Binding Trap 

Log 

This field will enable and disable the sending of trap log messages for IP-MAC binding. When 

enabled, the Switch will send a trap log message to the SNMP agent and the Switch log when 

an ARP packet is received that doesn’t match the IP-MAC binding configuration set on the 

Switch. 

IP Address 

Enter the IP address to bind to the MAC address set below. 

MAC Address 

Enter the MAC address to bind to the IP Address set above. 

All Ports 

Click this check box to configure this IP-MAC binding entry (IP Address + MAC Address) for all 

ports on the Switch.  

Ports 

Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC 

Address). Click the All check box to configure this entry for all ports on the Switch. 

Mode 

The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices 

are: 

95