D-Link xStack DGS-3426P User Manual - Interface Settings

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch 

Interface Settings 

The IP Address may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP 

address has not yet been changed, read the introduction of the xStack DGS-3400 Series CLI Manual

or return to Section 4 of this 

manual for more information. To change IP settings using the web manager users must access the IP Address menu located in the 

Administration folder. Open the 

Administration

 folder and click the 

Interface Settings

 menu link. The web manager contains 

two folders for which to setup IP interfaces on the switch, one for IPv4 addresses, named 

IPv4 Interface Settings

, and one for 

IPv6 addresses, named 

IPv6 Interface Settings

. 

IPv4 Interface Settings 

Click 

Administration

 > 

Interface Settings

 > 

IPv4 Interface Settings

 link, the following window will be displayed for the user 

to view. 

Figure 6- 3. IPv4 Interface Settings window 

To manually assign the Switch's IPv4 address and its related configurations, click the 

Add

 button, revealing the following window 

to configure. 

Figure 6- 4. IPv4 Interface Settings - Add 

To modify an existing Interface, click that interface’s hyperlinked 

Interface Name

, which will produce this window: 

Figure 6- 5. IPv4 Interface Settings - Modify

41