D-Link xStack DGS-3426P User Manual - Gvrp Settings
xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
that will be transmitting traffic for the VLAN. These ports can be either tagged or untagged.
Forbidden
en
Select this to specify the port as not being a member of the VLAN and that the port is forbidd
from becoming a member of the VLAN dynamically.
Click
Apply
to implem
GVRP Settings
ent changes made.
The
GVRP Settings
window, allows you to
determine whether the Switch will share its
VLAN configuration information with other
GARP VLAN Registration Protocol (GVRP)
enabled switches. In addition, Ingress Checking
can be used to limit traffic by filtering incoming
packets whose PVID does not match the PVID of
the port. Results can be seen in the table under the
configuration settings, as seen below. To view
this window, click
L2 Features
>
VLAN
>
GVRP Settings
.
Figure 7- 7. GVRP Settings window
Click
Apply
to implement changes made. See table below for description of parameters.
The following fields can be set:
Parameter Description
Unit
Select the switch in the switch stack to be modified.
From/To
included in the Port-based VLAN created
These two fields allows the range of ports that will be
using the 802.1Q Port Settings window, to be specified.
GVRP
the port to dynamically become a member
The GARP VLAN Registration Protocol (GVRP) enables
of a VLAN. GVRP is
Disabled
by default.
Ingress Check
ar between
Enabled
and
Disabled
.
Enabled
enables the
This field can be toggled using the space b
port to compare the VID tag of an incoming packet with the PVID number assigned to the port. If
the two are different, the port filters (drops) the packet.
Disabled
disables ingress filtering. Ingress
Checking is
Enabled
by default.
Acceptable
e that will be accepted by the port. The user may choose
All
,
Frame Type
This field denotes the type of fram
between
Tagged Only
, which means only VLAN tagged frames will be accepted, and
Admit_
which mean both tagged and untagged frames will be accepted.
Admit_All
is enabled by default.
123