D-Link xStack DGS-3426P User Manual - Section 5

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch 

Section 5             

Web-based Switch Configuration 

Introduction 

Logging on to the Web Manager 

Web-Based User Interface 

Basic Setup 

Reboot 

Basic Switch Setup 

Network Management 

Switch Utilities 

Network Monitoring 

IGMP Snooping Status 

Introduction 

All software functions of the xStack DGS-3400 switch series can be managed, configured and monitored via the embedded web-

based (HTML) interface. Manage the Switch from remote stations anywhere on the network through a standard browser. The 

browser acts as a universal access tool and can communicate directly with the Switch using the HTTP protocol.  

The Web-based management module and the Console program (and Telnet) are different ways to access the same internal 

switching software and configure it. Thus, all settings encountered in web-based management are the same as those found in the 

console program. 

Logging in to the Web Manager 

To begin managing the Switch, simply run the browser installed on your computer and point it to the IP address you have defined 

for the device. The URL in the address bar should read something like: http://123.123.123.123, where the numbers 123 represent 

the IP address of the Switch. 

NOTE:

 The factory default IP address is 10.90.90.90.  

This opens the management module's user authentication window, as seen below. 

26