Eaglemaster E5 Instruction Manual - page 13

Check-in range notification (on/off )

Arming the system within 8-seconds, press button          once on the 2way remote , the 

system will enable this Check- in range function.  

- With in 5 minutes, the 2-way remote will than give 1 beep sound every one minute for 5 

   cycles to remind the user within range.

- After 5 minutes , the Antenna icon will indicates under receiving status: 

For friendly usage, the 2-way remote will provide 2 beeps/ 3cycles and flashing icon           

after 35 minutes if the user is out of the receiving rage.  However, afterwards if the 2-way

remote detect the signal again from the system, 1 beep sound will be provided and flashing 

icon             will be ON to indicate the 2-way remote is within range.  

Note: If under Check-in range mode, if alarm triggered, this function will automatically

           turn off (disable).  

-12-

R

The 2way remote 

will respond:

Icon will on for 2sec. and give 1 beep 

sound to indicate the function has been 

turned ON. 

Full reception

Half reception

Weak signal 

Non reception

(flashing icon)

Reminder disarm status (Programmable) 

If programmed with " 1way reminder disarm status to 2way" feature ,  this function will 

reminder disarm status if disarming by 1-way remote control. The 2-way remote will display 

disarm icon and give 2 beep sound . 

Vehicle status checking

Turn on LCD display back light

The 2-Way remote offer the feature to check the current status of the car, simply press 

button           once within proper operation range. The main unit will send the signals to 

the 2-Way remote about the vehicle current status.  

Simply press button           once, the back light of LCD display will turn on 5 seconds and

also check the vehicle status.