Eaglemaster E5 Instruction Manual - - Reverse Warning :

Turbo mode: 

If programmed , the CH-5 channel will constant output when ignition turn on 1 minutes. It will

keeps the engine running after arriving at your destination by ignition off  for a programmed 

time 1/ 3/ 5/ 10 minutes. This allows the system's timer to conveniently cool down the turbo 

after you have left the vehicle.   

Note: in turbo mode time , if arming the system, sensors will be bypassed and LED flashing 

           Green color for a programmed turbo time.  

Important: Turbo mode should be used only in open areas. Never start and run the vehicle 

                     in an enclosed space such as a garage or carport.

- Channel-6 (-) output(programmable): 

This channel "Brown/black wire" is a negative (-500mA) output features, this channel can be 

programmed :  (1)- Arming output 1~120sec.   (2)- Press button       +      output 1~120sec. 

(1)- Arming output 1~120sec. if programmed, this channel will activate when arming, the 

       output  timing can be programmed from 1 to 120seconds.

(2)- Press button       +      output 1~120sec. If programmed, to operate this channel by press 

       button       +      for over 2sec. This channel will constant output for programme time.

Note: When this channel is outputting, if press button       +        once, it will stop outputting. 

- Channel-7 (-) output(programmable): 

This channel "Black/white wire" is a negative (-500mA) output features,  this channel can be 

programmed :  (1)- Disarming output 1~120sec.   (2)- Press button       +      output 1~120sec. 

(1)- Disarming output 1~120sec. if programmed, this channel will activate when disarming, 

       the output timing can be programmed from 1 to 120seconds.

(2)- Press button       +      output 1~120sec. If programmed, to operate this channel by press 

       button       +      for over 2sec. This channel will constant output for programme time.

Note: When this channel is outputting, if press button       +        once, it will stop outputting. 

- Red/black programme (+) input: 

This red/black (+) positive input can be programme three feature as: 

- Reverse warning : 

If programmed , connect to the (+)reverse back light.  when you are 

   reversing your car the siren will give a short warning chirp every one second. 

   Note: you can proceed the Reverse warning without siren chirps :  (1) when you activated 

           the Disarm w/o chirp before Ignition On.  (2)  when you reversing the Car simply press 

           the button          once. 

- Head warning : 

If programmed , connect to the (+)head light .  This feature will provide 

   pre-warning chirps if you forgot to turn off the head light while leaving the car. 

- Extra sensor (knock sensor) : 

If programmed , connect to the (+) optional extra 

   sensor ( knock sensor). This feature will paging the 2way remote while trigger the sensor.

2-way LCD display 

when armed: 

-20-

NOTE: 

you may disable this turbo mode 

after ignition turn off ,by press 

button         once, the CH-5 will 

stop outputting.

Flashing icon

2-way LCD display : 

+ Melody sound