Eaglemaster E5 Instruction Manual - page 25

This programming features is provide the owner to learn the new transmitter into the system 

memory. This system can expand 4 different transmitters, and comes from factory with two 

transmitters already programmed into the system memory (1-way & 2-way ) . 

Whenever you want to add or delete transmitter code , the procedures are as following:

1.

 Enter Valet mode, the LED on status. 

2.

 Turning ignition switch from ON to OFF and within 10 seconds, press Valet switch on-off

     for 5 times, siren will provide 3 long chirp.

3.

 Now you have insert your former (old)PIN code to release this programming mode. 

     For example your old PIN code is "2.5", turn ignition ON , LED start flashing (the times 

     of LED flashing is according to the 1st PIN code), While LED flashing 2 times then turn 

     ignition OFF, thus the 1st PIN code entered. Turn ignition ON again, LED start flashing, 

     while it flashing 5 times then turn ignition OFF, thus the 2nd PIN code entered.

     If the 2-digits PIN code entered correctly, the siren will provide 1 long chirp and the LED

     will flashing fast to indicate that the system is in Learning mode.

     Note: If enter not correct PIN code, siren will give 2 short chirps and exit this 

                mode and back to Valet mode. Please repeat procedure step # 4 again. 

4.

 Follow from 1-long chirp, LED flashing fast, 

It's available to learn the new transmitter into the 

     system by press any button once of the new  transmitter, siren will give 1-long and 1-short chirps 

     to indicate the first transmitter code learn into the system memory. 

     To learn the 2nd,3rd,4th new transmitters, simply press any button once on the each transmitter, 

     the numbers of siren short chirps is according to the numbers of the new transmitters learn into 

     the system memory . (Each time learning new code of remote, the old code will be erased, hence 

     you have to learn again.)

5.

 To exit this programming mode, if there is no new transmitters button been pressed, turn ignition

     to ON or within 20 seconds without any button pressed , siren will give 2 short chirps and back

     to the Valet mode. 

Transmitter programming:

Programme mode features:

-24-

Many of the operating settings of this unit are programmable. The programmable mode setting 

dictates how the unit operates.  

To enter programme mode and access Feature Change: 

1. Disarmed the system,  turn ignition from ON to OFF, within 10 seconds press valet Switch 

    ON-OFF for 5 times.  

2. Siren will 2 long and 2 short chirps. Then turn the ignition switch to ON, and LED will steady

    ON to confirm the system is in programme mode.   

3. To press the         button : select the item number , each time the       button is pressing, siren 

    will give a chirp sound to confirm.       

4. To press the         button: select the feature status, press the         button , siren will give short 

    chirp to confirm the feature has been programmed. 

Exit programme mode:

Under programming mode, if turning Ignition to OFF , the system will exit the programming mode 

and siren will give two short chirps .