Eaglemaster E5 Instruction Manual - page 15

- To DISARM the system :

To disarm your system within proper operating range, simply press button        once (while 

system in arm position). The system will respond two siren chirp, two light flash, doors unlock, 

Enable your engine starter, LED off. 

- Intrusion Alert:

Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will Indicates 

4 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following 

different triggering.

flash 2 times after a pause          Sensor 1st-stage triggered

flash 3 times after a pause          Sensor 2nd-stage triggered

flash 4 times after a pause          Door switch triggered

flash 5 times after a pause          Trunk switch triggered

flash 6 times after a pause          Hood switch triggered

Flash 7times after a pause          Ignition switch triggered

- 2-way LCD Intrusion Alert: 

Upon disarming the system, if the vehicle is attempted or intruded, the 2-way remote will respond 

2 short beep follow with melody sound, and LCD display will indicates different icons as under:

1st-stage sensor 

triggered

2nd-stage sensor

triggered

Door switch triggered

Trunk switch triggered

Hood switch triggered

Ignition switch triggered

Note:  Before the ignition turn on, you may realized again which zone been triggered by press 

                 button (status check) once, the LCD will display triggered zone again.  

-14-

2-way LCD display : 

+ Two beep sound