Eaglemaster E5 Instruction Manual - page 20

- Remote trunk open:

Simply press and hold button       over 2 seconds, the channel will output for 1 second pulse , 

to open the trunk. When armed if remote trunk open or close, the system will give one light 

flash and the 2-way remote will give one beep sound. The 2-way LCD display icon as under: 

Note: 

If trunk has been remote opened in arming position, trunk switch will delay sensing for 

           5 seconds, and the shock sensor will be bypassed. 

- Channel-5 (-) output(programmable): 

This channel "Gray/black wire" is a negative (-500mA) output features, this feature 

can be controlled " Dome light output  / Arm W/Engine running / Turbo mode) ".  

Dome Light: 

If programmed with the feature , the channel will constant output 30sec. when disarming .

Turn ignition switch ON will stop the channel output. 

Arm W/Engine running:  

If programmed with the "Arm W/Engine running, this feature for the car to keep engine 

running after arriving at your destination. 

To operate this feature by pressing        for 2sec. while driving or ignition ON , the 

siren will give one chirp and the LED will start flashing Green color, at the time the system is 

in standby mode, the owner must follow under process to activate the "Arm W/Engine 

running " mode.

(1) Within 15sec. Turn Ignition OFF (engine still keep running), open and close door to 

      leave the car. 

      Note: If within this 15sec. press any button once will exit the mode, LED off. 

(2) While leaving the car by open and close the door, within 5sec. press button       once,   

      the system will arm immediately, the parking lights will flash once every 5 seconds , and 

      the status LED will flashing Green color, however the engine will still keep running.

      The 2-Way remote will respond under icons flashing as long as turbo time finished.

Exit mode : 

Pressing button           once of the remote control within engine running mode , the system 

will delay 15 seconds and exit turbo mode, this delay time is allow the user using the key 

turn ignition on without stop the engine running.

NOTE:  1. In engine running mode, the sensor zone trigger will be bypassed.

              2. In engine running mode, if door, hood or trunk has been  triggered, engine will 

                  stop running and alarming the system, simply press button        to disarm .

2-way LCD display : 

2-way LCD display : 

Note: (1) Ignition ON does not allow to remote trunk 

                 open, unless one door is opened. 

           (2) Armed, if trunk opened over 1 minutes, the 

                2-way remote will give pre-warn beep sound.

-19-

(1)  After leaving the car, within 5sec. 

If press wrong button will exit mode.

(2)  After leaving the car, within 5sec. 

If without press         button will exit 

mode automatically.

Note: