Eaton Compass sit-to-stand Installation manual - page 11
11
Compass sit-to-stand
Installation Manual
COMPASS SIT-TO-STAND INSTALLATION MANUAL
Eaton.com/compass
SECTION III – Assembling the desk
cont’d.
NOTICE
Important considerations
Before starting, consider best orientation for cable and
component orientation
Plan carefully for the wire routing:
•
Assemble the control box last to allow use of the wire
pass-thru channels in the bottom surface of the housing
•
Which end of the desk will have cable chain?
•
Where will AC power cable be routed? Will it run in the
cable chain?
•
Which location is preferred for the control panel?
Route the cables to their approximate locations
Cables shown in figure illustrate routing typical of all types
of Compass STS desk
Actual cables are longer Gather the additional cable length,
coil it, and store in the worksurface support channel
AC Power Cable
- Route from center of support
(control box location) to end of desk near cable chain
AC wall plug exits thru side port in stiffener
Lift Column Cables
- Linear desks use (2) lift cables of
same length Route from control box area to lifts
Corner desks use (1) long and (2) shorter lift cables
Use the shorter cables for the lift columns closest
to control box Remove plastic filler strip from
worksurface Route cable from lift column through work
surface pathway into support, and along the stiffener to
control box area Replace the plastic strip
Assemble the control box
•
Control boxes have wire pass-thru channels in their
bottom surface to allow cables to pass from one end to
the other
•
The AC power cable cannot be easily routed through the
channels in the bottom of the control box
Orient the control box to best suit the route of the AC
power cable and attach with (2) #10 x 1-
3
⁄
4
" Phillips head
wood screws (B) at the center of the stiffener
Plug the AC power, control panel, and lift cables into
control box
NOTICE
Lift cables must connect to channel number 1 and go in
sequence
B. Install the lift control system and cables
Install control panel
The mount control panel to pre-drilled holes (left or right
side as desired) – using (2) #8 x
3
⁄
4
” Phillips flat-head wood
screw (E) Do not overtighten - the switch housing can
be damaged Pull the plastic filler strip from worksurface
pathway that is nearest to control panel and route cable
through the pathway into support Replace the plastic strip
Control
Panel
Filler Strip
Filler Strip
not shown
this side
Control Box
Worksurface
Support
Worksurface
Channel
Longer Lift
Cable
Short Lift
Cables
Cable Port
AC Power
Cable