Eaton Compass sit-to-stand Installation manual - page 12
12
Compass sit-to-stand
Installation Manual
COMPASS SIT-TO-STAND INSTALLATION MANUAL
Eaton.com/compass
SECTION III – Assembling the desk
cont’d.
Important considerations
FS desks may be assembled upside down on a flat surface
for easiest access to all screws and components or
assembled upright if desired
WARNING
During the assembly process, components may become
unstable Completed desk will be heavy To reduce the
risk of personal injury and product damage, always ensure
a sufficient amount of personnel are present during the
assembly process and final installation
•
Mount lift columns to pre-assembled worksurface / stiffener
Orient the electrical connector towards the center of
worksurface Secure with (4) M6 x 10 Phillips head screws
(D) into each lift motor housing No lock washers are used
Use a #3 Phillips bit. DO NOT TIGHTEN SCREWS.
NOTICE
Start all screws in their respective holes before tightening
Tighten the end screws first followed by the side screws
•
Assemble feet to lift columns using (4) M6 x 20 Phillips
Head screw (C) and
5
⁄
16
" lock washers (K) per lift. Use a #3
Phillips bit Ends of feet will be approximately even with
the back edge of worksurface and offset from the front
(user side) edge by approx 2"
C. Free standing desks
Refer to pages 4-5 for additional views of completed desks
•
Assemble foot to lift columns using (4) M6 x 20mm
screws,
5
⁄
16
" lock washers (do not tighten screws)
•
Connect lift column motor cables
•
Connect AC cord to AC outlet (temporarily)
•
Initialize lift motor system
•
Cycle lift motors to 18" twice and return to lowest position
- tighten all screws
•
Turn the entire assembly over and set it on its feet,
carefully move into final installation space To reduce risk
of property damage, DO NOT drag desk across flooring
surface
•
Install cable grommets into rectangular holes in
worksurface
•
Loosen each lift motor’s (4) M6 x 20mm screws
•
Cycle lift system to 18" twice and return to lowest position
- tighten all screws
Lift
Column
Front / user
edge
M6 x 20 screws
and
5
⁄
16
" lock
washers
M6 x 10
screws
Control pad
Feet
Electrical
connector
Pre-assembled
Worksurface
BOTTOM ISO VIEW OF CORNER DESK
BOTTOM VIEW OF LINEAR DESK
Feet offset from
front edge
Feet align to
back edge