Eaton Compass sit-to-stand Installation manual - page 14
14
Compass sit-to-stand
Installation Manual
COMPASS SIT-TO-STAND INSTALLATION MANUAL
Eaton.com/compass
SECTION III – Assembling the desk
cont’d.
D. Integrated Desks
Refer to pages 6-7 for additional views of completed
desks
Important considerations
STS Integrated desks are intended to be assembled in-line
with, and connected to, other Compass STS or stationary
desks The legs of the STS Integrated desk bolt to additional
STS Integrated desks or standard stationary desks to form a
unitized structure
WARNING
STS Integrated desks are not intended to be used in
conjunction with upper Compass accessories, i e , shelving
and/or overhead storage Doing so may cause risk of
personal injury and product damage
WARNING
During the assembly process, components may become
unstable To reduce the risk of personal injury and product
damage, always ensure a sufficient amount of personnel are
present during the assembly process
•
Attach legs to existing units if there are any
See Compass Installation Guide page 25 for leg
connection info
•
For corner desks – assemble the corner leg post
assembly per Compass Installation Guide page 20 It
can be assembled LH or RH Attach the short corner
foot to the post LH and RH are not interchangeable
•
Install (3)
1
⁄
4
-20 x ¾" hex head screws (F) into upper
threaded holes in each of the Legs Leave these
screws protruding
3
/
8
" – DO NOT TIGHTEN
•
Install the stretcher panels between legs using the
keyholes Leave bolts loose
•
Add upper lift brackets in 3 locations using key holes
Note orientation of brackets Tighten all the bolts
finger tight
•
Install plastic top caps (M) and other plastics covers
as necessary
1
⁄
4
-20 x .75
Hex head
screws (3)
per leg
Key holes
Stretcher panels
Corner leg
assembly
NOTE: Plastic covers for
channels not shown,
remove as necessary
Leg assembly
Short corner
foot assembly
Upper lift brackets
Note left / right
hand orientation