Eaton Compass sit-to-stand Installation manual - page 2
2
COMPASS SIT-TO-STAND INSTALLATION MANUAL
Eaton.com/compass
Table of Contents
SECTION I – GENERAL INFORMATION
About this guide
2
Contact information
2
Before you begin
3
Personal protective equipment
3
Tools required
3
Safety warnings and precautions
3
Desk capacity
3
Desk environment
3
SECTION II – PARTS IDENTIFICATION
Free standing linear type
4
Free standing corner type
5
Integrated linear type
6
Integrated corner type
7
Assembly hardware
8
SECTION III – ASSEMBLING THE DESK
A Assemble the work surface support
10
B Install the lift control system and cables
10
C Free standing desks
11
Assemble cable chain kit
13
D Integrated desks
14-17
Assemble cable chain kit
16
SECTION IV – OPERATION
Cabling the desk
11
Operating the height adjustable work surface
18-19
Document History
The following table shows this document’s revision
history:
November, 2017
First Publication – Pub No IB211001EN
About this Guide
This document contains general information about the
assembly and operation of Eaton’s Compass
™
sit-to-
stand desk system
Intended Audience
This document is intended for personnel experienced
at installing ergonomic / adjustable desk equipment
Technical Support
If you encounter any problems with this installation,
send an email and detailed description of the problem,
as well as contact information, to Technical Support at:
ToSupportESWorcesterMA@eaton com
Sales Representative and Contact Information
Contact your Eaton sales representative using one of
the methods below:
Phone
Call us toll free at 800-225-7348 (US only)
or 508-852-4300
Eaton
160 Gold Star Boulevard
Worcester, MA 01606
InfoESWorcesterMA@Eaton com
Web
Visit us at Eaton com/CompassSTS and click
on “Contact Us ” Complete and submit the
form as directed on our website
DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY
The information, recommendations, descriptions and safety notations in this document are based on Eaton Corporation’s
(“Eaton”) experience and judgment and may not cover all contingencies If further information is required, an Eaton sales
office should be consulted Sale of the product shown in this literature is subject to the terms and conditions outlined in
appropriate Eaton selling policies or other contractual agreement between Eaton and the purchaser
THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES
OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET OUT IN ANY
EXISTING CONTRACT BETWEEN THE PARTIES ANY SUCH CONTRACT STATES THE ENTIRE OBLIGATION OF EATON THE
CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES
In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or
otherwise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to damage or
loss of use of equipment, plant or power system, cost of capital, loss of power, additional expenses in the use of existing power
facilities, or claims against the purchaser or user by its customers resulting from the use of the information, recommendations and
descriptions contained herein The information contained in this manual is subject to change without notice
Compass sit-to-stand
Installation Manual