Eaton Compass sit-to-stand Installation manual - page 16
16
Compass sit-to-stand
Installation Manual
COMPASS SIT-TO-STAND INSTALLATION MANUAL
Eaton.com/compass
SECTION III – Assembling the desk
cont’d.
WARNING
During the assembly process, components may become
unstable Some components will be heavy To reduce the
risk of personal injury and product damage, always ensure
a sufficient amount of personnel are present during the
assembly process and final installation
•
Place worksurface assembly onto lift columns Carefully
guide the lift motor housings into their respective locations
CAUTION
Pinched electrical cables may cause risk of electrical
shock or equipment damage Use care and visually verify
to avoid pinching any previously installed cables
•
Secure with (4) M6 x 10 Phillips head screws (D) into each
lift motor housing. No lock washers are used. Use a #3
Phillips bit DO NOT TIGHTEN SCREWS
NOTICE
Start all screws in their holes before tightening
NOTE:
In certain cases, some bolts may be difficult to access
They can be installed after power is connected and the
work surface raised from its base position
•
After all lift motors are assembled, place desk assembly in
final location and level
•
Connect AC cord to AC outlet
•
Initialize lift system - per page 18
•
Cycle lift system to 18" twice
•
Tighten all lift motor screws
Install Cable Chain Kit
•
The kit parts are designed to allow attachment to either
the left or right stretcher of the assembled desk
•
Mount cable chain directly to worksurface using
(2) #10 x 1" Phillips head screws (A).
•
Mount to stretcher using (2) #8-32 X
1
⁄
4
" thread forming
screws (H) and (2) #8 flat washers (L).
Cable chain
#8-32 X
1
⁄
4
" screws
and # 8 flat
washers
#10 x 1"
wood
screws
Pre-assembled
worksurface
with cabling
M6 x 10 screws
(4) Per lift column
Lift
Column