Eberspächer EasyStart R Installation instructions manual - page 8
8
Please note!
What to do if …? / Service
Rapid red-green flashing of the mobile unit’s
LED display
If the LED fl ashes quickly red-green after the mobile unit
has been activated, check the following items.
• Has the antenna been correctly connected and installed
(see page 5)?
• Is the antenna in its original condition (ensure the free
end of the antenna has not been shortened or dama-
ged, see page 5)?
• Has the stationary unit been correctly wired (see circuit
diagrams at the end of the installation instructions)?
• Fuse inserted?
• Can the heater be switched on and off using the push-
button?
• Is the mobile unit being operated outside its range (see
page 3 ”General information“)?
• Further displays are described in the chapter „What to
do if …?“ from page 13 of the operating instructions.
If you are unable to remedy the fault or error, please con-
tact an authorised JE workshop or dial one of the service
phone numbers given below.
If you have any technical questions, a problem with your
radio remote control or the heater, dial the following ser-
vice phone number:
Telephone hotline
00 49 (0)800 / 12 34 300
Fax hotline
00 49 (0)1805 / 26 26 24
Service