Eberspächer EasyStart Remote Technical Documentation Manual - Pair Mode
VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 11
3 INITIAL STARTUP
CARRY OUT THE INITIAL STARTUP
For the initial startup, the following steps must
be carried out one after the other.
Insert the battery into the mobile unit.
Insert the battery supplied in the mobile
unit, as described in the EasyStart
Remote+ operating instructions, in the
“Maintenance / Replacing the Battery”
chapter. Do not activate the mobile unit yet.
Applying the operating voltage
The operating voltage is applied by insert-
ing the fuse into the fuse holder.
Automatic detection
Five seconds after applying the operating
voltage the button's LED starts to light up.
The radio remote control now checks which
heater is connected and configures the
Menu bar of the mobile unit.
Teaching the mobile unit
If the button's LED starts to flash, the mobile
unit can be “teached” (programmed).
Note on the Add display
The
Add function can be used to teach up to
4 mobile units to one stationary unit; but only
one mobile unit can make contact with the
stationary unit.
Notes on the AddE display
The
AddE function is used to only teach the
current mobile unit. All previously “teached”
mobile units are deleted.
PLEASE NOTE!
If the mobile unit is not teached within 30
seconds, the button's LED indicator goes out.
Press the button until the LED starts to flash.
Then teach the mobile unit.
TEACH MOBILE UNIT – Add TEACH MODE
Press the
or
button,
Add is dis-
played.
Pair mode
Add
Confirm Add teach mode by pressing the
button.
TEACH MOBILE UNIT – AddE TEACH MODE
Use the
or
button to select
AddE.
Pair mode
AddE
Confirm AddE teach mode with the
button.