Eddyfi Reddy User Manual - page 46

32 | www.eddyfi.com

Using Reddy with Sharck Probes

Getting Ready

1.  Connect the Sharck probe’s 160-pin ECA connector to the ECA connector on the right side of 

Reddy.

See chapter 1 for details about connector positions.

2.  Connect the Sharck probe’s encoder connector (12 pins) to the I/O connector on the right side of 

Reddy.

3.  If it is not already on, press the power button on the front of Reddy to turn it on.

Notes

•  You may connect and disconnect Sharck probes when the instrument is on. 

•  Reddy verifies the probe’s compatibility to make sure that the current setup is valid.

4.  In the backstage view, tap Project.

5.  Create a new inspection folder or open an existing one by tapping Create Inspection or Open 

Inspection, respectively.

Figure 5–8  Backstage view: Create/Open inspection

Figure 5–9  Creating an inspection project

6.  If you are creating a new inspection folder, type its name in the Inspection text box.

7.  Tap OK.