Eddyfi Reddy User Manual - page 49
of
82
| 35
Using Reddy with Sharck Probes
Figure 5–14 Component definition
3. Tap Next.
4. In Probe Selection, select the setup corresponding to the Sharck probe connected to Reddy.
Figure 5–15 Probe selection
5. Tap Next.
6. In Scan Definition, select the encoder and specify the type of scan.
Note
Do not configure the maximum probe speed at a value higher than 200.0 mm/s (7.9 in/s). By default,
the maximum density value is optimized at 4.0 samples/mm. We recommend that you avoid
modifying it.
Figure 5–16 Scan definition: configure scan