Eddyfi Reddy User Manual - page 57
| 43
Using Reddy with Sharck Probes
Figure 5–30 Sizing information
Analyzing Data with Reddy
Before analyzing data, if you want to include screen captures in your report, make sure that the check
box below is selected in the
Project section of the backstage view. If you do not, reports only include
summaries of your findings.
Figure 5–31 Take screen captures with defect report entry check box
To analyze data with Reddy, proceed as follows:
1. Find the file navigator at the bottom of the Magnifi GO front-stage view.
2. Tap the file that you want to open.
3. On the Layout ribbon, tap Select Layout, and then tap the layout that you want to use.
Figure 5–32 Selecting a layout
4. Review your data and move your cursor to an area of interest.
Impedance plane
of Depth C-scan
Impedance plane
of Length C-scan