Fadini Junior 633 Instruction Manual - page 15
pag 22
!
=
=
PROGRAMMING AND SELF-LEARNING OF THE OPERATION
1st Operation: unlock the unlocking handle lever with the coded key and pull it out the until it stops (beyond 90°) freeing the gate from
the Junior operator; then position the gate at about half of its course. Return the lock by closing the handle lever
As a safety measure, when the unlocking handle is freed, the electrical power supply to the Elpro 63 PCB is disconnected.
2nd Operation: Remove the electrical power supply to the electronic PCB by completely extracting the 230 V line fuse from its seat, found on the front,
underneath the Elpro 63 PCB.
Push and hold down the P button and then afterwards install the line fuse. After 2-3 seconds release the P button: the LP LED will begin to flash signalling
the programming phase
+90°
LP
LP
3rd Operation: learning of the run pattern and the slowdowns
It is possible to perform programming with the dedicated P button or else with an impulse form the coded remote control transmitter.
It is important that both end stops, for opening and closing, are installed. Position the magnetic or mechanical limit switches in
correspondence with the final opening and closing positions for the magnetic detector or the Junior feeler.
Push for an impulse: The Junior operator
will begin to move in opening
LP
B
eginning of the slowdown
Push for an impulse: The Junior
will begin to slow down until the
limit switch is detected
Push for an impulse: The Junior
will begin to move the gate in
closing
Beginning of the slowdown
Push for an impulse: The Junior will
begin to slow down until the limit
switch is detected
3.1
3.2
3.3
3.4
3.2
3.3
3.4
FA
D
IN
I
normal speed
slowdown
slowdown
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 24
End of programming: adjust the
Trimmer Force necessary to move
the gate
LP
LP
LP
LP
2-3 sec
LP
3.1
LP
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29
-
+
-
+
IMPORTANT:
programming Junior is performed at first installation. Even in absence of mains power , programming is
stored for any changes in the position of slow programming can be performed by the same procedure.
Adjust the Trimmer Force necessary to move the gate. This adjustment also determines the strenght and impact resistance
with an obstacle in slowdown. An high force to inertia of the gate is leads to incorrect installation according to safety
regulation EN 12445 and EN 12453
meccanica
FADINI
Elpro 63
Junior 633 - Junior 650
GB