Falcon Elan 90 Ceramic User Manual & Installation & Service Instructions - page 16

U109655                                                                       16

Australia

To  remove  metal  rub-off

Sliding pans on the hob - especially aluminium or copper 

pans - can leave marks on the surface. These marks often 

appear like scratches, but can easily be removed using 

the procedure described previously for 'Cleaning spills'. If 

the rub-off marks are especially stubborn, use a cleaning 

cream together with the razor scraper, as described in 

'Cleaning burned-on spills'.

Glide-Out Grill

The grill pan and grid should be washed in hot soapy 

water. After grilling meats or any foods that soil, leave to 

soak for a few minutes immediately after use. Stubborn 

particles may be removed from the grid using a nylon 

brush. Alternatively, the grill pan can be washed in a dish 

washer.

Before you remove any of the grill parts for cleaning, 

ensure that they are cool, or use oven gloves.

The grill pan can be easily removed for cleaning, as 

follows:

Remove the grill pan support frame by pulling the grill 

pan forward:

Lift the grill pan clear of the support frame.

The support 

frame is held to the side rails by two clips on each side:

For each side, support the side rail with one hand and 

with the other hand lift the frame up and out of the side 

clips:

For safety's sake, push the side rails back into the grill 

chamber.

If you need to remove the side rails to facilitate the 

cleaning of the grill chamber, you can unhook them from 

the grill chamber sides and wipe the sides clean with a 

soft cloth and mild detergent.

Do not use any abrasive substances.

DO NOT put the side runners in a dishwasher.

Once you have finished, hook the side rails back onto the 

sides of the chamber. To refit the frame, pull the side rails 

forward and, for each side in turn, support the side rail 

and press the frame down into the side rails. Replace the 

grill pan.

When refitting the grill pan, ensure that the wide rim is at 

the front:

Control Panel and Doors

Avoid using any abrasive cleaners, including cream 

cleaners, on brushed stainless steel surfaces. For best 

results, use a liquid detergent or our Multi-purpose 

Cleaner.

The same cleaner can also be used on the doors. 

Alternatively, use a soft cloth wrung out in clean hot 

soapy water. You can use the same method for cleaning