Falcon Elan 90 Ceramic User Manual & Installation & Service Instructions - page 26
U109655 26
Australia
Fit the new element and reassemble in reverse order. Check
the operation of the grill.
20. To Remove an Oven Inner Back
Open the oven door and remove the screws and washers
securing the inner back to the back of the oven. Carefully lift
away the inner back. Reassemble in reverse order, making
sure that the four screws and washers are fully tightened.
21. To Replace an Oven Fan
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover.
Disconnect the three terminals connected to the fan, noting
their position. Remove the oven inner back - see section 20.
Hold the fan blade and remove the centre nut (left hand
thread), two brass washers, fan blade and Circlip. Unscrew the
fan retaining nuts and washers (three off each) and lift the fan
away from the rear of the cooker.
Fit the new fan and reassemble in reverse order. Check the
operation of the oven.
22 To Replace an Oven element Thermal Cutout
Pull the cooker forward to gain access to the cover box. Undo
the cover screws and lift clear. The cutout is located on the
earth plate beside the oven element connections. Disconnect
the cutout wiring, undo the fixings that secure the cutout to
the earth plate, and remove.
Fit the replacement cutout and re-assemble in reverse order.
23. To Remove the Left hand Oven Bottom and Top
Elements
Bottom Element
Pull the cooker forward to access the cover boxes at the rear of
the unit. Remove the fixings that secure the cover and lift it clear.
Remove the 2 screws ‘A’ and allow the plate to drop down.
Remove the two screws B holding the element to the bottom
sheet.
Disconnect the leads, noting their positions.
Withdraw the bottom element. Fit the new element and re-
assemble in reverse order.
Top Element
Open the left hand oven door and undo the fixings that secure
the heat shield. Remove the top element bracket fixings and
withdraw the element. Replace the element and re-assemble in
reverse order.
Check that the oven operates satisfactorily.
24. To Adjust the Main Oven Door Angle
The Main Oven door bottom hinge can be adjusted to alter
the angle of the door. Loosen the bottom hinge fixing screws
and use the notch and flat-bladed screwdriver to move the
position of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity