Falcon Elan 90 Ceramic User Manual & Installation & Service Instructions - page 23
23 U109655
INSTALLATION
Check that the appliance is electrically safe when you have finished.
Australia
This shows the single-phase connection.
Check that the links are correctly fitted and that the
terminal screws are tight.
Secure the mains cable using the cable clamp:
Fixed Wiring
For connection to fixed wiring, i.e. flexible conduit,
remove the electrical terminal cover box on the back
panel. Remove the two screws and blanking plate from
the bottom flange of the cover box, so as to allow the
conduit through.
Fix the conduit-to-conduit mounting bracket on the back
panel. Connect the mains cable to the correct terminals
for your electrical supply type. Check that the links are
correctly fitted and that the terminal screws are tight.
Replace the electric terminal cover box, making sure that
the conduit is clear of the bottom flange.
Main Oven Light
Press the light switch in the main oven and check that the
light is working.
NB. The oven light bulb is not included in the
guarantee.
Hobplate
Turn on each plate in turn and check that it heats up.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven Check
Set the clock to the time of day. See 'The Clock' section in
the Users section of these instructions.
Turn on the ovens and check that the oven fans start to
turn. Turn off the ovens.
Fitting the Plinth
Loosen the three screws along the front bottom edge
of the cooker. Hook the central keyhole over the central
screw. Twist and fit each end keyhole over their respective
screws. Tighten the fixing screws:
Customer Care
Please complete your details in this Guide, and, after
making sure that the user knows how to operate the
cooker, hand over the Instructions.
Thank you.