Fellini 13-04522 Owner's Manual - Installation
N
OTE
: D
RAWINGS OF THE AIR CONDITIONER AND ACCESSORIES MAY DIFFER FROM THE PRODUCTS
.
UNPACKING THE AIR CONDITIONER
•
Remove the air conditioner from the packing carton. It is recommended to keep the carton
and packing material for storage or transportation of the unit. If you decide to dispose of
the packing material, waste recycling where possible.
• Do not forget to remove the top rail from the bottom of the packing carton.
• Remove tape and glue residue from surface before turning on the air conditioner. Rub a
small amount of liquid dish soap over the glue residue with your fingers. Wipe with warm
water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your air conditioner.
• Handle the air conditioner with care. We recommend that 2 persons move and install this
air conditioner.
ELECTRICAL SPECIFICATIONS
•
The electrical ratings for your air conditioner are listed on the rating plate of the unit.
• The air conditioner power cord ends with a LCDI grounded plug (Leakage Curent Detection
and Interruption). This device will circuit trip the power source if the nominal current
leakage between the cord shield and either load conductor exceeds a predetermined value.
The cord will remain out of power until the device is manually reset. This device protects
against electric shock and reduces fire risks in the power cord or combustible material nearby.
INSTALLATION
LCDI TEST
1.
Plug the power cord into a grounded outlet.
2.
Press on the TEST button - circuit should trip, cutting off power to the unit and
the RESET button pops out.
3.
Press on the RESET button to restore power (some models may have a pilot light
going on when power is restored).
Note :
If the reset fails, this means that an abnormal current leakage has been
detected. Do not use the air conditioner and/or attempt to reset the LCDI plug. Immediately
contact SUNRISE TRADEX Customer Service (see end of this book).
WARNING !
1.
DO NOT PRESS the TEST button while the air conditioner is operating.
2.
The TEST and RESET buttons should not be used as ON and OFF switches.
3.
The cord and the plug are not built to protect external loads or supply circuits.
4.
The LCDI cord and plug are intended for indoor use only.
5.
The power cord and plug must be connected into a properly rated grounded outlet. If you
do not have a grounded outlet available, contact a qualified electrician to have a
grounded outlet properly installed.
6.
Do not alter the power supply plug by removing the ground.
7.
Do not connect to an outlet used by other appliances ; ideally use on a single outlet circuit.
5