Fellini 13-04522 Owner's Manual - Unit Operation
9
UNIT OPERATION
• Plug the unit into a grounded outlet. Do not use an extension cord nor an adapter plug.
• In cooling mode, when turning your air conditioner off, always wait at least 3 minutes
before turning it back on. It will prevent overheating of the compressor and the air
conditioner from blowing a fuse or tripping a circuit breaker.
• Do not run your air conditioner in cooling mode when the outdoor temperature is below
17oC (62oF). The internal evaporator will freeze up and the unit will not operate properly.
PRESS ON/OFF TO TURN THE UNIT ON ; PRESS AGAIN TO TURN OFF.
COOLING MODE
1. Press the MODE button and set to COOL. The matching indicator light will go on.
2. Press (increase) or (decrease) to set room temperature - 17 to 30°C (62 to 86oF).
The set temperature will show on the LCD display. To alternate between
o
C and
o
F, press
and hold for 3 seconds both keys together.
3. Press to set fan speed : AUTO, LOW, MED or HIGH. Each level is matched with an
indicator light going on when selected.
AUTO :
This automatically sets the fan speed to provide an optimum comfort level based
on the set temperature. The fan speed will increase or decrease in order to adjust
the cooling airflow as per the set temperature. If the room temperature does not get
too warm, the fan speed will operate at LOW speed.
• This button can be activated only in COOL mode.
LOW :
Fan speed lowest level - for NIGHTIME and/or a SMOOTH cooling.
MED :
Fan speed medium level - for NORMAL cooling.
HIGH :
Highest velocity airflow - for MAXIMUM and FAST cooling.
• For maximum cooling efficiency, draw the curtains or blinds if the room is exposed to direct
sunlight. Do not place near a heat source.
• If the air conditioner is turned off or switched on from FAN or ENERGY SAVER mode,
upon turning the unit on to COOL mode, allow a 3 minute delay before the compressor
resume.
FAN MODE
The FAN mode provides ventilation and air filtration without cooling. When using the FAN
mode, the temperature settings cannot be adjusted but the current room temperature will show
on the LED display.
1. Press the MODE
button and set to FAN. The matching indicator light will go on.
2. Press to set fan speed to : AUTO, LOW, MED or HIGH. Each level is matched with an
indicator light going on when selected.
•
The AUTO fan speed cannot be used when in FAN mode.
• When in FAN mode, open the air vent (some models only).