Fernbedienung CV1000 User Manual - Programming The Cv1000
- 45 -
SLEEP : (TV Only)To turn off your TV after a period of 1 to 99 minutes.
Proceed as follows :
1. The remote must be in TV Mode with the “second” display screen being
shown.
2. Press and hold the LCD “SLEEP” Key until the LED remains on
(occurring after approximately 2-3 seconds) and display will show the
Sleep Setup Screen.
3. Release the “SLEEP” key.
4. Press and release the numeric keys (01-99) for the time required. The
LED will blink off to indicate keypress acceptance and the remote
display will return to normal operation.
5. TV Sleep Timer now set. Leave the Remote pointing towards the TV
with an unobstructed path.
To cancel the Sleep Timer, press and release the Power key in TV Mode
or press and hold the SLEEP key until the remote beeps twice.
Programming the CV1000
You program the CV1000 using the Setup key and following the
procedures below. Each keypress is acknowledged with an LED blink and
a beep from the sounder. 3 LED blinks and sounder beeps indicate an
incorrect or invalid entry.