Fernbedienung CV1000 User Manual - Important:
- 69 -
8. CBL/SAT Volume Control :
Some Cable and Satellite have their own volume control. By default in
CBL/SAT modes, the CV1000 Volume and Mute key control the TV
volume. To change the volume and mute control either to TV or CBL/SAT
for CBL/SAT mode, proceed as follows :
1. Press and release the TV mode key (TV must be in TV mode for this
procedure).
2. Press and hold setup key until the LED remains on and the Main Setup
Screen is shown.
3. Release Setup key.
4. Press and hold the Mute key for approximately 5 seconds. The LED will
blink, and stay off for the 5second period then blink once more to
indicate volume toggle acceptance. The display will return to the main
Setup Screen.
5. Remote Volume default is now set.
15 PROBLEMS AND TROUBLESHOOTING
. The remote doesn’t work or looses codes entered
Confirm with your original remote that the equipment works correctly
Make sure that you have pressed the corresponding mode key of the
equipment or device that you want to control.
If the listed code does not work, try the AUTOSEARCH method or
enter the next code of that brand.
To find the corresponding code for your equipment use the automatic
search.
· Check that the batteries have the correct polarity position.
The programming of the remote requires 2 AAA batteries (new). If the
remote looses codes within a few days/weeks the problem can be
solved by using 2 new batteries from the same brand.
· If the LED is lit permanently, in general it will be necessary to replace
the batteries.
Important:
The CV 350-2 must be used only in the way described in this
instruction manual and may not be used for a purpose not intended.