Fernbedienung CV1000 User Manual - 10) Programming A Macro
- 54 -
6. Display will show the Code Identification
Screen (Initially blank except for “SETUP”,
“INFO” and “CODE” labels). The display will
now show the code using the LCD digits. The
3 digits will be shown in sequence for 1second
each followed by a 0.5second gap where no
digits are shown. The LED will blink off for
each digit display. This sequence will only be
carried out once then display will return to the
Main Setup Screen.
7. Code
Identification is now complete. Press
and release the LCD “EXIT” key to return to
normal operation.
10) Programming a Macro
The Macro function allows you to store several sequences of IR
Commands (key presses). One press of the Macro key will execute the
whole sequence. A total number of 20 keystrokes can be stored under
each of the 9 available Macro keys.
1. Press and hold Setup key until the LED
remains on (occurring after approximately 2-
3 seconds) and the display shows the Main
Setup Screen.
2. Release Setup key.
3. Press and release the LCD “MACRO” Key.
Setup Screen - Code ID
SETUP
0
7
9
4
6
2
8
5
3
CODE
i
Blink Back Digits
Setup Screen - Main
SETUP
EXIT
SCREEN
MACRO
LEARN
CODE
SLEEP
P