Fernbedienung CV1000 User Manual - To Delete A Macro :

- 57 - 

5. It is not possible to include a Macro within a Macro. 

To Delete a Macro : 

1. Press and hold the Setup key until the LED remains on    (occurring 

after approximately 2-3 seconds) and the display shows Main Setup 

Screen. 

2. Release Setup key. 

3. Press and hold either the LCD or rubber MACRO key.  The LED will 

blink off to indicate the keypress acceptance and the Macro Delete 

Setup Screen will be shown.  Only set Macros will be shown. 

4. Press and release the digit key for the Macro that is to be deleted.  The 

LED will blink off and the Macro is deleted.  Use the EXIT key to abort if 

required. 

5. Macro deletion is now complete. 

11) Channel toggle key 

The Channel-Toggle “P

feature allows you to program in two specific channels and switch 

between them with a single key-press.  For example, you may want to 

switch between TV channels 123 and 456.  Programming the “P

will allow you to do this. 

Two sets of data are to be entered.  Each set of data can be up to 4 key-

presses and must be a minimum of 2. The first keypress in each set must 

be a Mode key.  The following keystrokes can be any other key (except for 

Mode, Macro, Setup and Screen) although in practice, these keys will 

usually be digit keys.  Note no “shifted” commands can be part of a “P

sequence and a SCREEN keypress counts as a keystroke.