Garmin APOLLO GX SERIES Service Manual - page 10
Garmin AT
Rev --
1-2
GX Service Manual
© 2004 Garmin AT
Sources for Soldering Standards
Electronic Industries Association
Engineering Dept.
2001 Pennsylvania Ave. N.W.
Washington, DC 20006
Also:
Global Engineering Documents
(800) 854-7179 (US & Canada)
(303) 397-7956 (International)
Institute for Interconnecting and Packing Electronic Circuits.
2125 Sanders Road
Northbrook, IL 60062
Tel (847) 509-9700
Fax (847) 509-9798
(www.ipc.org)
GPS Signal Source
A GPS signal source is required for Return to Service of the GPS Navigation units. See page 7-6.
Tools Required
• #1 Phillips screwdriver
• 5 lb.-in. torque wrench with #1 Phillips driver bit
• Needle
nose
pliers
• ¼" Nut driver
• 0.312" Nut driver
• Solder iron - grounded tip, temperature controlled (600-700 degrees F)
• Solder wick - “no clean,” Tech Spray p/n 1815-100F (0.060" dia) or 1816-100F (0.85" dia) or
equivalent
• Solder - “no clean,” Qualitek p/n NC600 (63/37), or equivalent
• Flux – “no clean,” Qualitek p/n 302 No-Clean flux or p/n rwrk wand, no-clean
• Slotted
screwdriver
• 0.050 Hex driver
• Glass cleaner, non-ammonia base
• Cleaning wipes – low lint
• Integrated
circuit
puller
Guide for using hand tools
1. Always use the appropriate size tool.
2. Exterior and interior screws should be tightened only with a torque screwdriver set to the
specified torque. Refer to the instruction manual supplied with the torque screwdriver. The correct
tightening torque is shown in each procedure.