Garmin APOLLO GX SERIES Service Manual - page 80
Garmin AT
Rev --
7-42
GX Service Manual
© 2004 Garmin AT
Step
General Instruction
Specific Steps
Expected Results
9
Set to Marker Menu. Turn the CURSOR CONTROL
knob to Main in the Controls
Field. Push the CURSOR
CONTROL knob. Turn the
CURSOR CONTROL knob CW
to Marker. Push the CURSOR
CONTROL knob. Turn the
CURSOR CONTROL knob CW
to Peak on the first Marker To
menu.
10
Turn on the
transmitter.
On the test box, press the PTT
switch to TX.
The RF modulation mask
should display on the screen.
11
Marker to peak of
carrier.
Press CURSOR CONTROL
knob.
Puts the marker on top of the
carrier.
12
Marker to Center
Freq.
Turn the CURSOR CONTROL
knob to Center Freq. in the
second Marker To menu.
13
Carrier to center of
screen.
Press CURSOR CONTROL
knob.
This center carrier on the
screen.
14
Turn CURSOR CONTROL knob
to Lvl field on the right side of
the display.
15
Set carrier reference
level.
Press SHIFT REF SET. Press
CURSOR CONTROL knob.
This sets the amplitude
reference to the peak of the
carrier.
16
Turn CURSOR CONTROL knob
back to Marker. Push CURSOR
CONTROL knob.
17
Select Main with the CURSOR
CONTROL knob. Push to select.
18
Move CURSOR CONTROL knob
to Center Freq.
19
Get exact center
freq.
Record center freq.
Example 127.499639 MHz.
20
Add or subtract 12.5
kHz to get new
center freq.
Add 0.0125 MHz for the upper
side band, or
Subtract 0.0125 MHz for the
lower side band.
Example: 127.499639 MHz +
0.0125 = 127.512139 +upper
side band.
Example: 127.499639 MHz -
0.0125 = 127.499639 lower
side band.
21 Set
Spectrum
Analyzer to new
center frequency.
Enter the result as the center
frequency using the keypad.
Push CURSOR CONTROL knob
to enter new Center Freq.