Garmin APOLLO GX SERIES Service Manual - page 100
Garmin AT
Rev --
8-4
GX Service Manual
© 2004 Garmin AT
Chassis Cover Replacement
This procedure describes the removal and replacement of the sheet metal chassis cover on the unit.
Note:
Every unit leaving the factory or authorized service center has a warranty warning label applied
to the rear panel and chassis cover. Removing this label leaves a distinctive checkerboard residue on
the unit. Before removing the chassis cover, verify the integrity of the label. Removal of this label by
anyone other than an authorized service center voids the warranty.
Parts Required
• 224-0403 SCREW UNDERCUT, PAN HEAD PHILIPS, 4-40 X 3/16, 82 DEGREE, STAINLESS
STEEL (7 required)
• 700-0069 CELL, POLYUR, 0.50 x 0.54 x 1/8” W/ ADHESIVE (GX55, 1 required)
• 700-0069 CELL, POLYUR, 0.50 x 0.54 x 1/8” W/ ADHESIVE (GX50, 60, 65, 2 required)
• 700-0068 CELL, POLYUR, 0.75 x 0.5 x 0.062” THK W/ ADHESIVE (GX50, 60, 65, 1 required)
• 565-0569-00 LABEL, WARRANTY WARNING
• ISOPROPYL
ALCOHOL
• CLEANING WIPES, LOW LINT
Removal
1. Before starting this procedure, fill out a Service Data Sheet if this has not already been done.
These are located at the back of this manual.
2. Power the unit off and disconnect power from the unit.
3. Remove the warranty warning label. Clean the label residue using a clean wipe and isopropyl
alcohol.
4. Remove the six screws on the sides near top of chassis.
5. Remove the screw on the back of the chassis near the top center.
6. Remove the chassis cover.
Replacement
1. Place the poly cell sponges on inside of the lid according to the assembly diagram.
2. Replace the chassis cover.
3. Replace the screw (224-0403) on the back of the chassis near the top center. Torque the
screws to 5.0 lb.-in
.
4. Replace the six screws (224-0403) on the sides near top of chassis. Torque the screw to 5.0
lb.-in
.
5. Test the unit to verify proper operation (see Return to Service procedures).
6. Properly mark a warranty warning label (565-0569-00) with your dealer number and repair station
number. Apply the label across the seam where the rear panel meets a chassis cover side or top.
7. Using the Service Data Sheet, reenter the customer configuration.