Garmin APOLLO GX SERIES Service Manual - page 163
GX Service Data Sheet (Manual P/N 560-7001-5XX)
Page 1 of 2
P/N: 561-6001-50
11/4/04
NOTE: GX Service Data Sheet procedures provide step by step
instruction for filling out this form.
PRELIMINARY INSPECTION
Technician
Date
RMA#____________________ Serial #
P/N_________________
Model
Mod
VISUAL DAMAGE
Visual Damage Initials: _____________Date: ___________________
____None ___Hardware
Damage
____Other
Visual Damage Details: _____________________________________
________________________________________________________
________________________________________________________
HIDDEN DAMAGE
Hidden Damage Initials_____________Date____________________
____No Damage Found
___Minor Damage
____Major Damage
Hidden Damage Details: ___________________________________
_______________________________________________________
_______________________________________________________
NORMAL MODE NAV INFO
Last Valid Pos:
____________________/___________________
CDI Scaling
____Automatic
____Manual
Direct-To Entry
____Never Clears ____May Clear
Date & UTC ____Correct
Not Correct______________________
Software Version: NAV________ GPS_________ COMM________
Database Expiration Date ______ / ______ / ____________
Database Part Number
138-
NORMAL MODE COM INFO(GX60/65)
COM SW V2.X
COM SW V1.X
Intercom SQLCH:______MIC1
Intercom SQLCH
_____MIC2 Intercom
Level______________
Transmit using: _______MIC1
Sidetone Level _____________
and MIC2
Headphone Level ___________
_____MIC1 only
_____MIC2 only
Intercom Level: ___________________________
Sidetone Level: ___________________________
Headphone Level: _________________________
TEST MODE NAV INFO
Serial Ports: Channel
RX
TX
1: ___________
____________
2: ___________
____________
IFR
APPROACH SAR
YES ________ ________
________
NO ________ ________
________
EEPROM BYTE Info
Address Description Data
Value
0219 Equipment
Run
Time
_______________
0224
Turn On Cycle Count
_______________
0229 EEPROM
Failures
_______________
0230 NVRAM
Failures
_______________
0231
Minor Math Errors
_______________
0232
Major Math Errors
_______________
0233 Exception
Interruption
_______________
TEST MODE COMM Info (Comm V 2.X only)
RX Squelch Level________________
MIC 1 Level________________
MIC 2 Level________________
FINAL ACCEPTANCE TEST
Technician: __________________ Date: ___________________
______Return to Service Procedures Completed (Chapter 11)
______RS232 Load Test per MET 154
______3D Pos, SNRs, Elev, & AZM Match Standard Unit
______Verify Lat/Long matches the standard unit.
______Verify Time and Date
______Verify Software Versions for:
Nav Application: ________ GPS _______ Display
______Emergency Search (nearest airport)
______Verify Board Rev Stickers
______Bump Test (Raise front of unit 3” and drop it. Observe
display for changes/blinking.)
______Check messages for return to service messages
FINAL INSPECTION
Inspector:________________________ Date: _______________
______Final Acceptance Test Checklist completed above
______Scan area of replaced components
______Backlighting (display and buttons)
______Unit and Board Configuration Correct (See Unit
Configurations)
______Verify UTC Time
______Covers, Rods and Screws Installed
______Verify customer setup with Service Data Sheet
______Replaced cover screws