Garmin GNC 420AW Installation Manual - page 94
Page 5-14
400W Series Installation Manual
Rev. E
190-00356-02
CDI (GNS 430W Only)
Selection Description
GPS
The GNS 430W CDI button is in the GPS state, and the GPS
ANNUNCIATE output is active. This annunciator output may be
required to be active for some installations.
VLOC
The GNS 430W CDI button is in the VLOC state, and the VLOC
ANNUNCIATE output is active.
NOTE
If it is desired to disable the GNS 430W CDI key, press MENU on the MAIN CDI/OBS
CONFIG page and select “Ignore CDI Key?”. This causes the field above the CDI key to
always display GPS, regardless of CDI key presses. This may be necessary for certain
EFIS systems where navigation sensor selection must be accomplished on the EFIS or its
control panel.
OBI SOURCE (GNS 430W Only)
Selection Description
Always GPS
The MAIN King Serial OBI outputs are always GPS. This is useful if it
is desired to switch a Bendix/King KI 229 or KNI 582 RMI pointer
independently from the GNS 430W CDI button.
Track CDI
The MAIN King Serial OBI outputs are GPS or VOR, and switchable by
the GNS 430W CDI button. This is useful if it is desired the
Bendix/King KI 229 or KNI 582 RMI pointer to display the same
navigation source as the GNS 430W CDI outputs.